Setting Up the Broadcast Accessory Pack for Podcasting

Quick Answer

Mount the PBA-1 boom arm to your desk, attach the shock mount and pop filter, then position your microphone for clear, plosive-free audio.

Step-by-Step Setup

1. Mount the Boom Arm: Clamp the PBA-1 to the edge of your desk or table. Tighten the clamp knob until it's secure. Ensure the arm can swing freely without hitting obstacles. Check that the clamp pad sits flush against the desk surface to avoid scratches or slipping.
2. Attach the Shock Mount: Screw the shock mount onto the threaded end of the boom arm. Align the mount so the microphone will face you when the arm is positioned. If the shock mount rotates too easily, tighten the locking ring slightly to hold its position.
3. Install the Pop Filter: Clip the pop filter onto the shock mount or boom arm arm. Position it about 2–3 inches from the microphone grille. Angle it slightly if needed to avoid blocking your view of the mic. Keep the pop filter between your mouth and the mic, not off to the side, or it won't stop plosives.
4. Connect and Position the Microphone: Attach your microphone to the shock mount. Adjust the boom arm so the mic is at mouth level, about 6–8 inches away. Speak past the pop filter, not directly into it. A common mistake is placing the mic too far away. Start close and adjust for clarity.
5. Test and Adjust: Record a short test clip. Listen for plosives, sibilance, or handling noise. Reposition the pop filter or boom arm as needed. Tighten any loose joints. If you hear low rumble, the shock mount may be touching the desk or cable. Reroute the cable away from the arm.

Product Facts

• Broadcast Accessory Pack: The rugged PBA-1 boom arm is suitable for use with Revelator, PX-1, PD-70, or nearly whatever mic you like. You can use this bundle with a wide range of microphones, not just PreSonus models, making it flexible for future upgrades.