SHK-2 Shock Mount: Reduce Noise on Your PreSonus Microphone

Quick answer

Attach the SHK-2 shock mount to your mic stand, then secure your PreSonus Revelator microphone inside the elastic cradle to block vibrations from desks, keyboards, and handling.

How to install the SHK-2 shock mount

1. 1. Mount the shock mount to your stand: Screw the SHK-2's threaded adapter onto your microphone stand or boom arm. Tighten it by hand until snug—over-tightening can strip the threads. Common mistake: using a tool instead of hand-tightening, which can damage the adapter. Check that the adapter is straight before moving on.
2. 2. Open the elastic cradle: Gently spread the two elastic bands on the SHK-2. They are designed to stretch, but pulling too hard or at an angle can weaken the elastic over time. Common mistake: trying to force the mic in without fully opening the bands, which risks tearing.
3. 3. Secure your microphone: Place your PreSonus Revelator microphone into the cradle, ensuring the body sits evenly between the bands. Release the bands slowly so they grip the mic firmly. Common mistake: positioning the mic off-center, which can cause uneven tension and reduce isolation effectiveness. Give the mic a gentle tug to confirm it's locked in place.
4. 4. Adjust the angle and test: Tilt the shock mount to your preferred recording angle using the swivel joint. Then tap the stand or desk lightly while monitoring your audio—if you hear a thud, re-check the elastic tension. Common mistake: assuming the mount fixes all noise; it only stops vibrations transmitted through the stand, not room echo or plosives. Pair the SHK-2 with a pop filter for best vocal clarity.

Product facts

• SHK-2 Shock Mount: The SHK-2 shock mount isolates your microphone from vibrations of the physical world: clacking mechanical keyboards, clumsy mic handling noise, or your cat jumping on your desk. This means you can record or stream without unwanted rumble and noise ruining your audio, even in a less-than-perfect room.